Deepwater Horizon hasn't finished collapsing yet?

An anonymous but seemingly knowledgeable commenter elseweb says that the worst is yet to come.

All the actions and few tid bits of information all lead to one inescapable conclusion. The well pipes below the sea floor are broken and leaking. Now you have some real data of how BP's actions are evidence of that, as well as some murky statement from "BP officials" confirming the same. [...] To those of us outside the real inside loop, yet still fairly knowledgeable, it was a major confirmation of what many feared. That the system below the sea floor has serious failures of varying magnitude in the complicated chain, and it is breaking down and it will continue to.

What does this mean?

It means they will never cap the gusher after the wellhead. They cannot...the more they try and restrict the oil gushing out the bop?...the more it will transfer to the leaks below. Just like a leaky garden hose with a nozzle on it. When you open up the nozzle?...it doesn't leak so bad, you close the nozzle?...it leaks real bad,
same dynamics. [...]

This down hole leak will undermine the foundation of the seabed in and around the well area. It also weakens the only thing holding up the massive Blow Out Preventer's immense bulk of 450 tons. In fact?...we are beginning to the results of the well's total integrity beginning to fail due to the undermining being caused by the leaking well bore.

The first layer of the sea floor in the gulf is mostly lose material of sand and silt. It doesn't hold up anything and isn't meant to, what holds the entire subsea system of the Bop in place is the well itself. The very large steel connectors of the initial well head "spud" stabbed in to the sea floor. The Bop literally sits on top of the pipe and never touches the sea bed, it wouldn't do anything in way of support if it did. After several tens of feet the seabed does begin to support the well connection laterally (side to side) you couldn't put a 450 ton piece of machinery on top of a 100' tall pipe "in the air" and subject it to the side loads caused by the ocean currents and expect it not to bend over...unless that pipe was very much larger than the machine itself, which you all can see it is not. The well's piping in comparison is actually very much smaller than the Blow Out Preventer and strong as it may be, it relies on some support from the seabed to function and not literally fall over...and it is now showing signs of doing just that....falling over.

Dear God, what a shit-shower this is....